Features:

1. The use of simulation structure design, with the real car control feeling, to achieve full scale stepless speed, high-speed driving, rapid acceleration, deceleration, braking, reversing, left turn, right turn.

2. Applicable sites: flat land, sand, mud, grass.

3. 4WD drive: front and rear upright spring damping, double-wishbone independent suspension system.

4. 2.4G full-proportional synchronized remote control system . Full proportional throttle/steering.

5. Metal differential, metal differential cup, powder planetary gear, powder active gear, powder main gear.

6. Metal CVD front drive shaft, metal rear dogbone, metal wheel cups.

7. Three-wire 17G digital servo.

8. 7.4V, 18650-1500mAh Li-ion battery (T plug), discharge multiplier 15C.

9. New remote control panel function: rudder volume size adjustment.

10. 16 ball bearings for the whole vehicle.

11. Metal second floor plate, metal front and rear arm code, metal mid-drive shaft.

12. The car shell adopts high toughness explosion-proof PVC car shell.

13. Equipped with LED headlights; (three modes: constant light, slow flash, fast flash)

14. Equipped with a head-up wheel.

15. Simulation of bigfoot tires, strong grip

1. This remote control car is only suitable for high-speed driving. Because the generator will make a strange noise when driving at low speed, this is a normal phenomenon not a fault.

2. The shell of the remote control car is covered with a film protection, if the shell has scratches then you can tear off the film.

Charging Voltage: 7.4V 1500mAH

Control Channels: 4 channels

Dimensions: 12" x 9"x 4"

Charge Time: 3 hrs

Run Time: 15-18 min

 Electric: Lithium Battery

Material: Metal, Plastic

Package Includes:Batteries,Operating Instructions,Remote Controller,USB Cable

Remote Control: Yes

Remote Distance: 360ft

Scale: 1:16

State of Assembly: Ready-to-Go

Steering servo: Three-wire 17G digital servo

Throttle servo: 2840 Brushless motor

Wheelbase: 7.5 inches

1: Charging protection: constant current and constant voltage balanced charging, protection function for battery overcharge and overcurrent.

2: Motor anti-seize protection: overload work, the motor stops working.

3: High temperature protection: when the working temperature is higher than the set situation, the drive control circuit to stop working, and then resume work after the temperature drops to a safe value.

4: ESC low voltage power-off function, the battery is lower than 6.3-6.4V or so, automatic power-off to prevent damage to the battery over discharge.